How to Remove a Screw Without a Screwdriver? – Expert Ans

How to Remove a Screw Without a Screwdriver

Have you ever tried to remove a screw without a screwdriver? Probably you did not manage to do it and now you think that it is a rigorous task. But hey! You should know that there are various ways in which you can get it done! We are going to guide you through some methods of getting rid of screws without a screwdriver!

Method 1: Use a Knife or a Scissors

Surely you have a sharp knife (regardless of whether it is small or big) or a pair of scissors (again the size does not matter), then do not worry! These tools can be used to remove a screw!!

All you have to do is just insert the tip of the knife or the sharp edge of the scissors into the groove of the screw head! Then you need to twirl the blade or the scissors counterclockwise for a little while. Continue twirling until the screw falls off.

Method 2: Use Pliers or a Wrench

Another way of removing screws is to use pliers or a wrench. You have to choose the right pliers or wrench size and ensure it will fit around the screw head. Then just clamp the pliers or wrench around the screw-head tightly and turn it counterclockwise. Put a lot of pressure and continue turning until the screw starts becoming loose. After a little while, you will be able to remove the screw by hand!!

Method 3: Use a Rubber Band

You can also use a rubber to remove a screw. You have to put a rubber band over the screw-head. It is necessary to make sure that it is centered. Use your finger to press the rubber band down. Then just turn it counterclockwise. At one point, the screw will just fall off.

Method 4: Use a Coin

Lastly, if you do not have access to any of the aforementioned tools, use a coin to get rid of the screw! Put the edge of the coin into the groove of the head of the screw. Turn the coin counterclockwise while putting immense pressure. Continue turning the screw until it becomes loose enough to be removed by hand.

Now what if it is a Phillips Head Screw? Then follow these steps:

How to Remove a Phillips Head Screw Without a Screwdriver

To remove a Phillips head screw with a screwdriver, follow these steps:

  1. Choose the correct size screwdriver: Make sure you select a screwdriver that fits the size of the screw head. Using a screwdriver that’s too small or too big can damage the screw and the tool.
  2. Insert the screwdriver into the screw head: Hold the screwdriver perpendicular to the screw head and insert the tip into the center of the screw head.
  3. Apply downward pressure: Use your non-dominant hand to hold the screwdriver in place, while your dominant hand applies downward pressure to turn the screwdriver counterclockwise.
  4. Turn the screwdriver counterclockwise: Slowly turn the screwdriver counterclockwise until the screw loosens and can be removed.
  5. Remove the screw: Once the screw is loose, use your fingers or pliers to remove the screw from the surface.

Remember that if it is a flat-head screw then you can even use a toothbrush or even a credit card to remove it!

To conclude, removing a screw without a screwhead may appear to be a challenge, but as you read above, it is a piece of cake if you have the right tools and know the techniques!!

Related Post:

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top