SDS drill bits are supposed to be hard and sustainable, but they may break unexpectedly sometimes due to various reasons. You probably think that removing a broken SDS drill bit is a tiresome job, but actually, it can be done quite easily if you use the right tools and apply the right techniques.
This article will lay down all the methods of removing a broken SDS drill bit easily. Just keep reading!
Tools you’ll need:
- Safety glasses
- Needle-nose pliers
- Center punch
- Hammer
- Lubricant (such as WD-40 or PB Blaster)
- Extractor bit (optional)
Remove a Broken SDS Drill Bit (Step-by-Step)
Step 1: Put on your safety glasses
Before attempting to remove the broken SDS drill bit, make sure you are wearing proper eye protection. This is important as drilling creates tiny metal particles that can fly into your eyes and cause serious injury.
Step 2: Inspect the broken bit
Take a good look at the broken bit and see if any of it is protruding from the hole. If you can grip the bit with needle-nose pliers, gently try to twist and pull it out. If the bit is flush with the surface, you’ll need to use a different technique.
Step 3: Use a center punch
Using a center punch, make a small indentation in the center of the broken bit. This will give you a starting point for drilling and help prevent your drill bit from slipping off target. Be sure to use a center punch that is slightly smaller than the diameter of the broken bit.
Step 4: Drill into the broken bit
Choose a drill bit that is slightly smaller than the broken bit, and start drilling into the center of the broken bit. Use light pressure and take your time. If the bit starts to spin or bind, stop drilling and apply some lubricant.
Step 5: Extract the broken bit
If you’re lucky, the broken bit will come out on its own as you drill. If not, use needle-nose pliers to gently twist and pull the broken bit out. If the broken bit is still stuck, you can try using an extractor bit.
An extractor bit is a special tool designed to remove broken screws, bolts, and drill bits. It works by gripping the broken bit and turning it counterclockwise as you drill.
Removing a broken SDS drill bit can be a tricky process, but with the right tools and techniques, it can be done quickly and safely. Remember to take your time, use proper eye protection, and apply lubricant as needed. Good luck!
Now have you realized that removing a broken SDS drill bit is not so difficult? However, it can be complicated unless you use the right tools and follow the right techniques.
Make sure that you take your time, use the required eye protection and apply lubricant while following the above-mentioned steps. Hopefully, you will get the job done quite easily!!
