You may be wondering how to hang shelves, cabinets or other heavy objects on your walls. Well, you might have to drill through metal studs. You may have heard that it is a daunting job. Right? Perhaps it is not so difficult!!
Do you want to learn how to do it easily?
:strip_icc()/SCW_171_03-5ee31e5e9b3e487d91d17af63b1e159d.jpg)
Then just follow the instructions given below and get the job done!
- Gather your tools: You’ll need a power drill, a metal drill bit, a hammer, and safety gear such as eye protection and gloves.
- Choose the right drill bit: Not all drill bits are suitable for metal drilling. You’ll need a high-speed steel (HSS) or cobalt drill bit with a pointed tip and a sharp cutting edge. Make sure the drill bit matches the size of the hole you want to make.
- Mark your spot: Use a pencil or marker to mark the spot where you want to drill. Double-check that there are no electrical wires or pipes behind the metal stud.
- Start drilling: Put on your safety gear, hold the drill steady, and start drilling at a slow speed. Use the hammer to tap gently on the drill bit to create a small pilot hole. This will prevent the drill bit from slipping on the metal surface.
- Increase the speed: Once the pilot hole is made, you can increase the speed of the drill and continue drilling until you reach the desired depth. Use a steady, even pressure, and avoid applying too much force, as it can cause the drill bit to break.
- Clean up: After you’ve finished drilling, use a vacuum or a brush to clean up any metal shavings or debris.
But hey! Don’t think that it’s gonna be a piece of cake every time. Here are some common challenges you may encounter:
- Hardness: Metal studs are typically made of steel and can be very hard, which can make it difficult to drill through them, especially if you’re using a low-quality drill bit.
- Brittleness: Steel can also be brittle, which means that if too much pressure is applied during drilling, the stud can crack or break.
- Difficulty finding the stud: Depending on the construction of the wall, it can be difficult to locate the exact position of the metal stud, which can make it harder to drill through it in the right place.
- Limited space: If the metal stud is located in a tight or hard-to-reach space, it can be challenging to get the necessary leverage to drill through it.
- Heat buildup: Drilling through metal can generate a lot of heat, which can damage your drill bit or even cause it to break. It’s important to use a cooling lubricant or to periodically pause drilling to allow the bit to cool down.
Now what do you think? Do you still consider the task to be difficult? I guess the answer is “no”! Just follow the aforementioned steps and hang any kind of object on your walls comfortably. However, bear in mind that you have to wear safety gear and be cautious at all times while drilling through your walls.
